Omnibus F4 V3 - iBUS SetupYouTube↗  IA↗(long shot)
Science & Technology  8.9K views 172 likes 3 dislikes   26 Jun 2018
Mirko FPV 13.7K subscribers Italy YouTube↗


Please select the problem
You must specify your email and describe the problem in detail
Describe your problem in detail if it's not obvious

Click to Play Video Click to Play Video
Hello everyone, I'm Mirko, and today we connect i-BUS receivers to Omnibus F4 V3 Flight Controller
Ciao a tutti, io sono Mirko, e oggi colleghiamo i ricevitori i-BUS al Flight Controller Omnibus F4 V3
In this video I will use an FS-iA6B but the process is the same for the X6B or the other iBus receivers
In questo video userò un FS-iA6B ma il procedimento è lo stesso per l'X6B o gli altri ricevitori iBus
IA6B IBUS port is this above
Nell'iA6B la porta IBUS è questa qua sopra
then we connect the cable making sure that the signal is at the top, the positive at the center and the ground at the bottom.
quindi colleghiamo il cavo assicurandoci che il segnale sia in alto, il positivo al centro e la terra in basso.
X6B i-bus connector is this one
Il connettore i-bus dell'X6B è questo qua
also in this case the signal cable goes up, the positive in the middle and the ground down.
anche in questo caso il cavo segnale va in alto, il positivo al centro e la terra in basso.
After pre-tin we connect the wires in these 3 pads that correspond to the UART6 port
Dopo aver prestagnato colleghiamo i fili in questi 3 pad che corrispondono alla porta UART6
Starting from the bottom we connect the Ibus cable in the first pad
Partendo dal basso colleghiamo il cavo Ibus nel primo pad
positive in the third
il positivo nel terzo
and ground in the fourth
e la terra nel quarto
As we said, the X6B wires are connected in the same pads and in the same order.
Come abbiamo detto i fili dell'X6B si collegano negli stessi pad e nello stesso ordine.
Now we connect the card to the PC and start Betaflight
Ora colleghiamo la scheda al PC e avviamo Betaflight
We click on Connect and we go to Ports
Clicchiamo su Connetti e andiamo in Ports
Here we activate SERIAL RX in UART6 since we connected the receiver on this port
Qui attiviamo SERIAL RX nella UART6 visto che abbiamo collegato la ricevente su questa porta
then we click SAVE AND REBOOT.
quindi clicchiamo SAVE AND REBOOT.
Now let's go to CONFIGURATION
Adesso andiamo in CONFIGURAZIONE
we scroll down and in RECEIVER we select SERIAL-BASED RECEIVER
scorriamo verso il basso e in RECEIVER scegliamo SERIAL-BASED RECEIVER
In this drop-down menu we choose IBUS, since that FlySky radios use this protocol.
In questo menu a tendina scegliamo IBUS, visto che le radio FlySky usano questo protocollo.
So we click on SAVE AND REBOOT
Quindi clicchiamo su SAVE AND REBOOT
Now let's go on RECEIVER and try our Radio Control.
Adesso andiamo su RECEIVER e proviamo il nostro Radiocomando.
Perfect, everything is fine
Perfetto, è tutto apposto
This was my tutorial on how to configure the Ibus receivers in the Omnibus F4 V3 flight controller
Questo era il mio tutorial su come configurare i ricevitori Ibus nel flight controller Omnibus F4 V3
Thanks for watching the video, please like and subscribe.
Grazie per aver visto il video non dimenticate di iscrivervi al canale e di mettere mi piace.
You can also support me on Patreon by clicking the link at the end of the video.
Se volete potete supportarmi anche su Patreon cliccando il link a fine video.
Similar videos:

Holybro Kakute F7 - Flysky iBus Setup
Mirko FPV
1.4K views 58 likes 1 dislikes 09 Aug 201880% match

Bardwell F4 AIO - Betaflight iBus Setup
Mirko FPV
2.6K views 60 likes 4 dislikes 24 Feb 201875% match

Omnibus F4 V2 - Betaflight iBus Setup
Mirko FPV
20.2K views 282 likes 9 dislikes 09 Jul 201775% match

Betaflight F3 FC - iBus Setup
Mirko FPV
3.8K views 54 likes 2 dislikes 17 Nov 201745% match

Mamba F4 Mini Power Tower - FLYSKY IBUS SETUP
Mirko FPV
4.9K views 124 likes 3 dislikes 13 Jun 201940% match

FLYSKY FS-A8S - Bind & Betaflight Setup
Mirko FPV
6.5K views 118 likes 5 dislikes 04 Sep 201839% match

Mamba F7 Super Stack - FLYSKY iBUS Receiver Setup
Mirko FPV
704 views 45 likes 1 dislikes 02 Aug 202033% match


Omnibus F4 V3 - Sbus & Telemetry
Mirko FPV
12.8K views 230 likes 10 dislikes 29 Jun 201833% match

SP Racing F3 - i-Bus Setup
Mirko FPV
12K views 151 likes 7 dislikes 31 Aug 201732% match

FLYSKY Fli14+ - Bind & Betaflight Setup
Mirko FPV
9.8K views 207 likes 3 dislikes 09 Dec 201830% match

Holybro Kakute F7 - Frsky F.port Setup (Sbus, SmartPort & Telemetry)
Mirko FPV
7K views 126 likes 5 dislikes 11 Aug 201830% match

FrSky R9 Slim & Slim+ Bind & Failsafe
Mirko FPV
5.1K views 124 likes 5 dislikes 05 Feb 201928% match

Mamba F4 Mini Power Tower - Frsky SBUS & Telemetry
Mirko FPV
9.4K views 253 likes 8 dislikes 11 Jun 201927% match

Frsky R-XSR - F4 Flight Controller Telemetry Setup
Mirko FPV
18K views 263 likes 12 dislikes 17 Jan 201827% match

FlySky FSI6 - Telemetry!
Mirko FPV
10.7K views 100 likes 9 dislikes 10 Nov 201726% match

Omnibus F4 V3 - Firmware Upgrade
Mirko FPV
14.3K views 207 likes 9 dislikes 25 Jun 201825% match

Frsky F.Port - Betaflight Setup
Mirko FPV
5.3K views 159 likes 7 dislikes 12 Jun 201825% match


Settings Privacy About Contact Donate